Have a question? Call/Text 918-720-7802 for immediate assistance!

HDPE/MDPE Quick Guide - Manual Fusion (Step 4 of 7)

Posted by Ben Murphy on

  1. Heat Soak
  • To close, SNAP the pipe ends sharply against the heater to ensure full contact.
  • At this point, RELAX the force without breaking contact with the heater.
  • Engage the LOCKING CAM. (Except when using a 2CU)
  • Maintain contact of pipe ends against the heater with no force during the entire HEAT SOAK time.

Share this post



← Older Post Newer Post →